Unchecked input for a loop condition in Progressive Robot hMailServer 6.0.0 through 6.3.6 allows a remote unauthenticated attacker to stop the server carrying mail. The server bounds the mail it generates in response to a message - a rule forward, reply or copy, an account forward, a Sieve redirect, vacation or notify, a bounce, an out-of-office reply - by a counter it carries in the message's X-hMailServer-LoopCount header, and makes no more once the counter reaches the configured rule loop limit (5 by default); that is what ends a forwarding or auto-reply cycle in a bounded number of hops. X-hMailServer-LoopCount is an ordinary header that is not stripped from mail arriving from outside, and the server read it with a signed conversion and no validation, so a count below zero passed every test against the limit: a sender who sets X-hMailServer-LoopCount to a negative value, or on the Linux builds to a value above the 32-bit signed range that the conversion wraps to a negative one, lifts the bound, and a message that enters a generated-mail cycle then loops up to about two thousand million times, each hop a queued message and a delivery, filling the queue and disk and stopping mail service. The Sieve notify action (from 6.2.22) consulted no limit at all, and its increment of the count could overflow a signed integer; and an account could reset the counter on its own mail through a Sieve editheader of the header (from 6.2.22) or a rule Set header value action (all versions) ahead of a forward or redirect.